1.When selecting tools for pop rivets, should they be selected according to the diameter above the crown edge of the pop rivet or the diameter of the pull rod below the crown edge?
A:When selecting the core pulling rivet gun, it should be selected according to the rod diameter of the rivet rather than the diameter of the brim. The reason is that the rivet rod will break at the brim after the pop rivet is riveted. If you use the 3 * 8 pop rivet, the tool of 3.2 can also be used.
2.If the drill hole diameter is too large and the rivet brim diameter is small, will there be any other impact on the riveting effect except for the appearance?
A:If the drill hole diameter is too large and the rivet brim diameter is small, it may be loose. If it is not loose, it is almost no problem.
3.After pulling the pop rivet with the manual rivet puller, should the rivet core inside be completely pulled out?
A:For ordinary pop rivets, the part of the rivet core is left inside after being riveted with tools, that is, the rivet rod under the brim is broken, and the rod at the head is still left inside.
Post time: Dec-14-2022