Attention should be paid to the following issues:
3. The calibration ring of riveting nut gun is used to adjust the riveting stroke. It can be adjusted as needed. It is worth noting that when adjusting the length of riveted bolts, open two handles and adjust the head cover. The length of the riveting bolt is slightly longer than that of the riveting nut. Tighten the adjusting nut and the gun body together.
4. Open your hands, pull out all bakelite, set corresponding rivet nuts at the end of rivet bolts and clamp them, and push the bakelite to rotate the gun head bolts. Then insert the rivet nut into the rivet and press it with both hands. At this time, the rivet nut expands and the workpiece rivets. Then the rubber ball is pulled out and the rivet nut is pulled out of the threaded hole. The rivet nut device can be ended.
Note: when using manual rivet nut gun. If the cover is found to be loose, tighten it in time. After use, the bolts shall be protected from damage.
Post time: Dec-29-2021